Dnotomista Trash Fansub

ANATOMIA ...proprio quel minuto tagliamento, che si fa delle membra de' corpi umani da' medici, per veder la compositura interna di essi corpi: e quegli, che esercita cotale arte, e detto NOTOMISTA. Qui per simil. Lat. anatomia dissectio
 
IndiceIndice  FAQFAQ  CercaCerca  Lista UtentiLista Utenti  GruppiGruppi  RegistratiRegistrati  Accedi  
***** 20th Century Boys - Chapter 3: Our Flag ***** Amalfi - Megami no hoshu *****

Condividi | 
 

 How you can Mount LEDS in Sections

Andare in basso 
AutoreMessaggio
yunaoled




MessaggioTitolo: How you can Mount LEDS in Sections   Ven Dic 02, 2011 10:25 am

Mounting of sunshine Giving off Diodes or LEDs on the pcb panel requires some kind of special tools, like a soldering iron and solder. These power tools could be acquired from electronic component providers or hobby shops.

1

Identify the good and bad devices of LEDs. Generally, the more lead of the LED signifies positive polarity however, many producers supply LEDs getting leads of equal length having a mark to point the polarity. In this situation, consult the LED datasheet to look for the polarity.||LED Module

2

Determine the polarity from the LED mounting pads around the PCB panel. If your circuit diagram isn't available, the pads could be tracked to obtain the polarity. The positive pad is the one which connects towards the positive terminal from the energy source, as the negative terminal is attached to the ground.

3

Place the leads from the first LED in to the mounting holes around the PCB, so that the positive LED lead adopts the opening for that positive pad, and also the negative LED lead adopts the opening for that negative pad.

4

Slightly bend the LED leads around the bottom from the PCB, to ensure that the LED doesn't drop out whenever you turn the PCB over for soldering.

5

Turn the PCB panel over, and put it on the flat working surface. You should use some small products underneath its sides to supply clearance for that PCB when it is surrended.||LED Panel Light

6

Warmth the soldering iron, and hang its temperature to around 450 Celsius.

7

Put the solder around the junction from the PCB pad and LED lead, and touch it using the tip from the soldering iron. The solder will immediately melt and flow to pay for the information. Take away the soldering tipas soon because the solder flows. Continue doing this process for that other LED lead(s).

8

Stop the surplus leads that extend past the soldered points utilizing a cutting tool.

9

Continue doing this trimming process for those LEDs.||LED DownLight

Tips & Alerts

The LEDs which come within an SMD package have no leads. They've only devices which are soldered on the PCB pads. Installing of such LEDs is simpler compared to ones with leads, because the soldering is performed along the side of the board the LEDs are put on.

Don't touch the soldering iron tip with bare hands because it is very hot, and can cause serious burns.

Always solder in well-ventilated areas because the fumes in the solder may affect breathing.
Tornare in alto Andare in basso
Visualizza il profilo dell'utente
 
How you can Mount LEDS in Sections
Tornare in alto 
Pagina 1 di 1
 Argomenti simili
-
» Cosa disse Dio a Mount Shasta.

Permessi di questa sezione del forum:Non puoi rispondere agli argomenti in questo forum
Dnotomista Trash Fansub :: Trash Movies(Se volete, contribuite pure.)-
Andare verso:  
Statistiche